Re: Balun One Nine: cutting R1
Posted: Tue Sep 05, 2023 8:23 pm
Or here?
SWLing Post Message Board
This is the official message board and discussion group of the SWLing Post
https://swling.net/
Balun One Nine: cutting R1
Page 2 of 2
Re: Balun One Nine: cutting R1
Posted: Tue Sep 05, 2023 9:15 pm
that one is the V2, no need to scrape anything it does not have the center tap even if the PCB shows it
Re: Balun One Nine: cutting R1
Posted: Tue Sep 05, 2023 9:45 pm
Interesting. Thanks, Andrew.
Re: Balun One Nine: cutting R1
Posted: Fri Sep 22, 2023 1:11 am
The antenna works great. That null is deeeeeep!
I'd like to put it in the rotator I have on the roof. My question now is about the recommended 3-meter height: Would that be from the ground, or from the roof itself?
Thanks for the great antenna design!
I'd like to put it in the rotator I have on the roof. My question now is about the recommended 3-meter height: Would that be from the ground, or from the roof itself?
Thanks for the great antenna design!
Re: Balun One Nine: cutting R1
Posted: Fri Sep 22, 2023 5:41 am
from the "ground plane" if the roof and/or its structure are conductive (e.g. concrete and iron) then 3m from roof will be okrjzastaury wrote: ↑Fri Sep 22, 2023 1:11 am The antenna works great. That null is deeeeeep!
I'd like to put it in the rotator I have on the roof. My question now is about the recommended 3-meter height: Would that be from the ground, or from the roof itself?
Thanks for the great antenna design!