Balun One Nine: cutting R1

Do you have a question about choosing a radio, installing an antenna, or are you simply trying to figure out how to find that elusive station on the dial? This is a place where you can ask your question and seek guidance from a wide variety of radio enthusiasts. No questions are too simple. You will be treated with respect here.
rjzastaury
Posts: 9
Joined: Mon Jun 06, 2022 10:53 pm

Re: Balun One Nine: cutting R1

Post by rjzastaury »

Or here?
Attachments
2023-09-05_2.jpg
2023-09-05_2.jpg (54.88 KiB) Viewed 22970 times
User avatar
Andrew (grayhat)
Posts: 295
Joined: Sat May 28, 2022 5:56 am
Location: JN63pn

Re: Balun One Nine: cutting R1

Post by Andrew (grayhat) »

that one is the V2, no need to scrape anything it does not have the center tap even if the PCB shows it :)
rjzastaury
Posts: 9
Joined: Mon Jun 06, 2022 10:53 pm

Re: Balun One Nine: cutting R1

Post by rjzastaury »

Interesting. Thanks, Andrew.
rjzastaury
Posts: 9
Joined: Mon Jun 06, 2022 10:53 pm

Re: Balun One Nine: cutting R1

Post by rjzastaury »

The antenna works great. That null is deeeeeep!

I'd like to put it in the rotator I have on the roof. My question now is about the recommended 3-meter height: Would that be from the ground, or from the roof itself?

Thanks for the great antenna design!
User avatar
Andrew (grayhat)
Posts: 295
Joined: Sat May 28, 2022 5:56 am
Location: JN63pn

Re: Balun One Nine: cutting R1

Post by Andrew (grayhat) »

rjzastaury wrote: Fri Sep 22, 2023 1:11 am The antenna works great. That null is deeeeeep!

I'd like to put it in the rotator I have on the roof. My question now is about the recommended 3-meter height: Would that be from the ground, or from the roof itself?

Thanks for the great antenna design!
from the "ground plane" if the roof and/or its structure are conductive (e.g. concrete and iron) then 3m from roof will be ok
Post Reply